Page 11 - Iscar_Article_Brochure
P. 11

or feed rate) will meet possibilities of the feed
        drive.  Also, the power consumption should not
        be too high. The method, MF – moderate feed
        milling, lies between traditional rough milling and
        the FF technique. And again, the milling cutter is
        a key player in this process.


        The cutting edge angle of an MF milling tool is
        approximately 30°, an increase when compared
        to FF tools. This reduces fz and maintains the
        necessary chip thickness but allows greater
        depths of cut, hence metal removal rates
        remains high. The increased cutting power is
        less of a problem for the heavy-duty main drives,
        therefore moderate feeds in combination with
        the appropriate tool geometry provides the
        necessary results. There are two types of ISCAR
        MF cutters. The HELIDO 600 UPFEED has
        different design configurations: endmills, face
        mills and replaceable milling heads with a thread
        connection for the FLEXFIT system.
















































                                                                                          11
   6   7   8   9   10   11   12   13   14   15   16