Page 65 - MILLING CATALOG p549-788
P. 65
USER GUIDE CAMFIX DIN 26623-1
CAMFIX Chucking Instructions Please be careful when In order to prevent too deep insertion of the
clamping cylindrical shank cutting tools into CAMFIX cutting tools, the short length ER16, 20, 25, 32,
holders such as ER collet chucks or EM holders. In 40 collet chucks and EM 6-50 mm endmill holders
are equipped with permanent stoppers.
cases when the diameter of the shank is smaller than
the CAMFIX through hole, it may penetrate into the Stopper washer
drawbar mechanism area and prevent proper clamping.
Correct clamping Wrong clamping
4 7
Locking
jaws
Face ER chucks
contact A special washer is installed as a permanent stopper.
Preset Locking No face
screw jaws are contact
not located
correctly
Use a preset screw to The cutter shank
prevent the cutter shank enters into the locking
from entering into the mechanism zone,
clamping mechanism preventing the drawbar
zone, so the drawbar locking jaws to reach their
locking jaws can correct clamping position.
function correctly.
613
