Page 51 - Iscar_Article_Brochure
P. 51

5  Cutter positioning


                                                                To avoid a clash between the tool (or the internal
                                                                edge of the insert) and the workpiece, the distance
                                                                E   between the tool axis to the workpiece axis
                                                                  w
                                                                should be
                                                                where w is the width of the wiper flat of an insert.

                                                                This recommendation takes cutter positioning
                                                                (fig.3) to the safe side. As can be seen in fig.1,
                                                                even if                   or even lower (depends on the
                                                                workpiece diameter and the geometry of the tool),
                                                                no clash will occur.

                                                                A case, at which the cutter body is cleared with
                                                                respect to the workpiece, and the inserts have an
                                                                internal cutting edge (like for ramping operations),
                                                                allows machining with E =0.
                                                                                         w















































                                                                  Fig. 3. Cutter Positioning



                                                                                          51
   46   47   48   49   50   51   52   53   54   55   56