Page 42 - MILLING CATALOG p319-550

SLOTTING & SLITTING CUTTERS USER GUIDE

Inserts
LNHT 1106...HT inserts should be used if a straight groove or shoulder are needed.

When using the other inserts, the machined surface is grooved due to the butterfly insert shape.

Side Wall Flatness Depending on the Inserts Being Used

Designation Number of Side Flatness Side Flatness Application Half Side Tools Axial
LNKX 1106... Cutting Edges ap5 H (mm) ap=10 H (mm) Double Face MIlling Depth of Cut ap (mm)

4R+4L Flat 0.45 ap ap Stock=0-10
Stock=0-10
LNMT 1106... 4R+4L Flat 0.45 Half side Milling Stock=0-10
Stock=0-10
LNHT 1106 - N(1) 2R+2L Flat Flat ap Stock=0-10
Stock=0-10
LNKX 1106... 4R Flat 0.45 Half side milling Stock=0-10
Stock=0-10
LNMT 1106... 4R Flat 0.45 ap Stock=0-10

LNHT 1106 - R(2) 4R Flat Flat

LNKX 1106... 4L Flat 0.45

LNMT 1106... 4L Flat 0.45

LNHT 1106 - N(1) 2L Flat Flat

(1) Use of 8 cutting edges (4R+4L) is possible only when ap≤5 mm, otherwise 4 cutting
edges (2R+2L) can be used

Configuration Guide for Full Slot FDN/SDN... CALN11 Cutters ap-7
7
Designation Number Bottom Slot Insert Radius ap Half Side Tools
of Cutting Flatness R (mm) Axial Depth of
H (mm) Application Cut W (mm)
Edges
W W=14-19.5
LNHT 1106... 2R+2L 0.45 0.8
LNKX 1106... W=14-19.5
W=14-19.5
LNMT 1106... 2R+2L 0.45 0.8

LNHT 1106 - N(1) 2R+2L Flat 0.8

WÊ-Ê11.0 R
WH

LNHT 1106... - N LNKX 1106... (LNHT 1106... - R
R.H./L.H. LNMT 1106... R.H. only

R.H./L.H.

Page 482 Page 481 Page 481

358 ISCAR