Page 88 - Aluminum_Machining_catalog_2023

INDEXABLE MILLING INSERTS
X45PN-R-S X75PN-R-S
LNAR 1106 (PCD)
Tangentially Clamped Milling L 15°
Inserts with a Brazed PCD APMX 45°
Tip for Machining Aluminum 2.0
S 2.6 RE 0.4 Chxa°
1.75 W1
PN-R-S
Single R.H. cutting edge PCD insert
Dimensions Tough 1 Hard Recommended
Machining Data

ap fz
Designation W1 L S RE Ch a° APMX ID8 ID5 (mm) (mm/t)
LNAR 110604PN-R-S 6.00 11.11 10.76 0.40 - 90 5.00 • • 0.10-2.00 0.10-0.25
LNAR 110604X45PN-R-S 6.00 11.11 10.70 - 0.4 45 5.00 • • 0.10-2.00 0.10-0.25
LNAR 110620X75PN-R-S 6.00 11.11 10.72 - 0.15 75 5.00 • 0.10-2.00 0.10-0.25
• The chamfered corner used for reduced chipping on the machined component edges • Use ID5 for aluminum alloys with <12% silicon
• Use ID8 for aluminum alloys with >12% silicon • The inserts are supplied with spare screws

PCD
Recommended Machining Conditions
ISO Grade DOC mm Material Vc N/mm Fee mm/tooth Cutting Edge
<2.0 Aluminum-wrought alloys <12% silicon 300-3000 0.05-0.25
ID5 <2.0 Chipboard Fiberboard Plastics 2000-3000 0.05-0.25
<2.0 Copper Brass alloys 500-1500 0.05-0.25
N <2.0 Aluminum >12% silicon 250-1000 0.05-0.25 Sharp
<2.0 Aluminum <12% silicon 300-3000 0.05-0.25
ID8
<2.0 Chipboard Fiberboard Plastics MMC 2000-3000 0.05-0.25
200-600 0.05-0.25

LNAR 1106PN-R-S-W
(PCD)
Tangentially Clamped Wiper L 30º
Milling Inserts with a Brazed PCD
Tip for Machining Aluminum
S W1
A single R.H. cutting edge PCD insert
Recommended
Dimensions
Machining Data

fz
Designation W1 L S ID5 (mm/t)
LNAR 1106PN-R-S-W 5.98 11.26 10.75 • 0.10-0.25
• The chamfered corner is used for reduced chipping on the machined component edges • The wiper insert should not be used with LNAR 110620x75PN-R-S inserts
• For D.O.C., cutting speed recommendations and grade data, see page 86

regular insert
wiper insert

0.01 ref

0.25 ref
wiper length 4.6 ref
D (cutter)

86 ISCAR Scan the QR code for additional information.
Enter the item description in the search field to access additional related data.