Page 165 - MILLING CATALOG p319-550

LNKX/LNMT 1106 S W1IC328
Tangentially Clamped Inserts IC928
with a Very Positive Chipformer L IC950
and Reinforced Cutting Edge APMXIC808
IC908
Dimensions RE IC910 Recommended
DT7150 Machining Data
Tough 1 Hard IC4100

MILLING INSERTS
ap fz

Designation W1 L S RE APMX(1) (mm) (mm/t)
5.00 • • • • • • 1.50-5.00 0.15-0.20
LNKX 1106PN-N MM 6.00 11.16 11.00 0.80 • • • 1.50-5.00 0.17-0.25

LNKX 1106PNTN MM 6.00 11.16 11.00 0.80 5.00 • • • • • 1.50-5.00 0.17-0.25
5.00 • •
LNMT 1106PN-N MM 6.00 11.16 11.00 0.80

• Molded chipformer to produce positive cutting • Reduced cutting forces enable higher feed capability • LNKX... is peripherally ground for accuracy and improved surface

finish • LNMT... is an economical utility insert • LNKX1106PNTN MM insert has a reinforced chamfered land • 4 R.H. and 4 L.H. cutting edges when used on F90LN...

cutters • For cutting speed recommendations, see pages 542-547

(1) DOC when the insert is on the cutter

For tools, see pages: F90LN-N11 (203) • FDN-CALN11 (349) • SDN-CALN11 (359)

PN-N-MM PNTN MM

LNHT 1106 PN-R HT S W1 10° Ref.
Tangentially Clamped Inserts L APMX RE
with 4 Straight Right-Hand RE
Cutting Edges

Dimensions Tough 1 Hard Recommended Machining Data

IC928 ap fz
IC908
Designation W1 L S RE APMX(1) IC910 (mm) (mm/t)
10.00 2.00-7.00 0.15-0.25
LNHT 1106PN-R HT 5.97 11.16 11.00 0.80 •••

• Right-hand insert with 4 cutting edges • Can machine a 90° shoulder according to the table below • For cutting speed recommendations, see pages 542-547
(1) APMX=10 mm for cast iron applications (for each pass), APMX=8 mm for steel applications
For tools, see pages: F90LN-N11 (203) • FDN-CALN11 (349) • SDN-CALN11 (359)

Mismatch as a function LNHT 11.. ∆W
of tool diameter ∆h=8

Dtool ∆W 8
40 0.12
50 0.06
63 0.03
80 0.04
100 0.01
125 0.02

481