Page 167 - MILLING CATALOG p319-550

X45PN-R-S ID8X75PN-R-S
ID5
LNAR 1106 (PCD) L 15°
Tangentially Clamped Milling APMX MILLING INSERTS
Inserts with a Brazed PCD Tip 45° 2.0
for Machining Aluminum 0.4 Chxa°
2.6
S 1.75 RE W1
PN-R-S Single R.H. cutting edge PCD insert

Dimensions Tough 1 Hard Recommended
Machining Data

ap fz

Designation W1 L S RE Ch a° APMX (mm) (mm/t)
90 5.00 • • 0.10-2.00 0.10-0.25
LNAR 110604PN-R-S 6.00 11.11 10.76 0.40 - 45 5.00 • • 0.10-2.00 0.10-0.25

LNAR 110604X45PN-R-S 6.00 11.11 10.70 - 0.4 • 0.10-2.00 0.10-0.25

LNAR 110620X75PN-R-S 6.00 11.11 10.72 - 0.15 75 5.00

• The chamfered corner used for reduced chipping on the machined component edges • Use ID5 for aluminum alloys with <12% silicon • Use ID8 for aluminum alloys with

>12% silicon. • The inserts are supplied with spare screws. • For D.O.C., cutting speed recommendations and grade data, see pages 542-547

For tools, see pages: F90LN-N11 (203)

Regular Insert
Wiper Insert

Wiper Length 4.6 Ref 0.01 Ref
D (cutter) 0.25 Ref

LNAR 1106PN-R-S-W (PCD) L 30º
Tangentially Clamped Wiper S
Milling Inserts with a Brazed PCD W1 A single R.H. cutting edge PCD insert
Tip for Machining Aluminum
Recommended
Dimensions Machining Data

ID5 fz

Designation W1 L S (mm/t)
0.10-0.25
LNAR 1106PN-R-S-W 5.98 11.26 10.75 •

• The chamfered corner is used for reduced chipping on the machined component edges. • The wiper insert should not be used with LNAR 110620x75PN-R-S inserts.

• For D.O.C., cutting speed recommendations and grade data, see pages 542-547
For tools, see pages: F90LN-N11 (203)

Regular Insert
Wiper Insert

Wiper Length 4.6 Ref 0.01 Ref
D (cutter) 0.25 Ref

483