Page 48 - ISCAR FACE GROOVING LINES

FACE GROOVE-TURN LH

HFHR/L-6T CDX H H OAH
Integral Toolholders for DAXN-DAXX CW B
External Facing HFHR/L --6T10 HBH
WF OAL
WF2
Right-hand shown
CDX
.826

INCH

Designation CW CDX H B OAL WF DAXN(1) DAXX(2) LH OAH HBH

HFHR/L 25.4-30-6T15 .236 .670 1.000 1.000 6.000 1.050 1.18 1.50 1.420 1.39 - SR M6X16 DIN912 HW 5.0
HFHR/L 25.4-38-6T20 .236 .790 1.000 1.000 6.000 1.050 1.50 1.97 1.540 1.43 - SR M6X16 DIN912 HW 5.0
.236 .980 1.000 1.000 6.000 1.050 1.97 2.76 1.730 1.47 - SR M6X16 DIN912 HW 5.0
HFHR/L 25.4-50-6T25 .236 1.260 1.000 1.000 6.000 1.050 2.76 3.94 2.000 1.47 - SR M6X16 DIN912 HW 5.0
.236 .790 1.000 1.000 6.000 1.050 3.94 7.09 2.000 1.47 - SR M6X20 DIN912 HW 5.0
HFHR/L 25.4-70-6T32 .236 1.260 1.000 1.000 6.000 1.050 3.94 7.09 2.000 1.47 - SR M6X16 DIN912 HW 5.0
.236 1.260 1.000 1.000 6.000 1.050 7.09 15.80 2.000 1.57 .10 SR M6X16 DIN912 HW 5.0
HFHR 25.4-100-6T20

HFHR/L 25.4-100-6T32
HFHR/L 25.4-180-6T32

• DGN & GRIP 6.. inserts can be used only with right-hand tools, HGPL 6.. inserts with left-hand tools • For user guide, see pages 161-173
(1) Minimum penetration diameter
(2) Maximum penetration diameter
For inserts, see pages: DGN/DGNC/DGNM-C (79) • DGN/DGNM-J/JS/JT (82) • GRIP (70) • GRIP (full radius) (72) • HFPR/L (68)
• HFPR/L (full radius) (69) • HGPL (75)

Groove can be widened with no limitation toward or away d
from the center except for the following tools: D

HFHR/L-#-30-6T15
Dd

1.18 .28

1.22 .16 Limitation of widening toward
center (d) depends on the major
1.26 .04 diameter (D) as per chart

≥1.30 0

46 ISCAR