Page 97 - ISCAR FACE GROOVING LINES
P. 97
GDMY IC830±0.1 30 Ref.
Utility Double-Ended Inserts IC8250
for Grooving and Turning CDX IC8087° 6.4
IC908
DAXN IC20CW
IC5010RE
IC428BW
METRIC FACE GROOVE-TURN
Dimensions Tough 1 Hard Recommended
Machining Data
Designation CW RE CWTOL(1) RETOL(2) BW DAXN(3) CDX(4)
GDMY 808 f turn f groove
8.00 0.80 0.05 0.050 6.00 50.0 27.00 • • • • • • ap (mm/ (mm/
(mm) rev) rev)
• 1.00-4.80 0.32-0.56 0.18-0.34
• DMIN for internal machining = 65 mm • For cutting speed recommendations and user guide, see pages 161-173
(1) Cutting width tolerance (+/-)
(2) Corner radius tolerance (+/-)
(3) Minimum axial grooving diameter
(4) Cutting depth maximum
For tools, see pages: • GAFG-R/L-8 (87) • GHFG-R/L-8 (83) • GHFGR/L-8 (84)
GDMY ±.004 1.18 Ref.
Utility Double-Ended Inserts
for Grooving and Turning CDX 7° .252
DAXN CW
RE
BW
Dimensions INCH Recommended Machining Data
Tough 1 Hard
IC830 ap f turn f groove
IC8250 (IPR)
Designation CW RE CWTOL(1)RETOL(2) BW DAXN(3) CDX(4) IC808 (inch) (IPR)
GDMY 808 IC908 .0071-.0134
IC20
IC5010
IC428
.315 .031 .0020 .0020 .236 1.97 1.063 • • • • • • • .039-.189 .0126-.0220
• DMIN for internal machining = 2.56" • For cutting speed recommendations and user guide, see pages 161-173
(1) Cutting width tolerance (+/-)
(2) Corner radius tolerance (+/-)
(3) Minimum axial grooving diameter
(4) Cutting depth maximum
For tools, see pages: • GAFG-R/L-8 (87) • GHFG-R/L-8 (83) • GHFGR/L-8 (84)
95
