Page 98 - ISCAR FACE GROOVING LINES
P. 98
FACE GROOVE-TURN GDMY (full radius) ±0.1 30 Ref.
Utility Double-Ended Full Radius 7°
Inserts for Grooving and Profiling CDX 6.4
DAXN CW
RE
BW
M ETRIC Recommended Machining Data
Dimensions Tough 1 Hard
IC830 ap f turn f groove
IC8250 (mm/rev) (mm/rev)
Designation CW RE CWTOL(1) RETOL(2) BW DAXN(3) CDX IC808 (mm) 0.32-0.67 0.18-0.34
GDMY 840 IC908
IC20
IC5010
IC428
IC806
8.00 4.00 0.05 0.050 5.60 50.0 25.00 • • • • • • • • 0.00-4.00
• Can cut arcs to 250° • DMIN for internal machining = 65 mm • For cutting speed recommendations and user guide, see pages 161-173
(1) Cutting width tolerance (+/-)
(2) Corner radius tolerance (+/-)
(3) Minimum axial grooving diameter
For tools, see pages: • GAFG-R/L-8 (87) • GHFG-R/L-8 (83) • GHFGR/L-8 (84)
±.004 1.18 Ref.
GDMY (full radius) CDX 7° .252
Utility Double-Ended Full Radius
Inserts for Grooving and Profiling
DAXN CW
RE
BW
Dimensions INCH Recommended Machining Data
Tough 1 Hard
IC830 ap f turn f groove
IC8250 (IPR) (IPR)
Designation CW RE CWTOL(1) RETOL(2) BW DAXN(3) CDX IC808 (inch) .0126-.0264
GDMY 840 IC908 .0071-.0134
IC20
IC5010
IC428
IC806
.315 .157 .0020 .0020 .220 1.97 .984 • • • • • • • • .000-.157
• Can cut arcs to 250° • DMIN for internal machining = 2.56" • For cutting speed recommendations and user guide, see pages 161-173
(1) Cutting width tolerance (+/-)
(2) Corner radius tolerance (+/-)
(3) Minimum axial grooving diameter
For tools, see pages: • GAFG-R/L-8 (87) • GHFG-R/L-8 (83) • GHFGR/L-8 (84)
96 ISCAR
