Page 181 - MILLING CATALOG p319-550
P. 181
SDMT-PDR-RM L/ICIC328
Insert with Helical Cutting Edges IC830
for 90° Shoulder Milling BS RE S IC928
IC5400
Dimensions Tough 1 Hard IC808
IC910
MILLING INSERTS
Recommended Machining Data
ap fz
Designation LS RE BS (mm) (mm/t)
0.80 1.60 • • • 1.20-11.80 0.08-0.15
SDMT 1205PDN-RM-M 12.70 5.00 0.80 1.60 • •• 1.20-11.80 0.07-0.20
SDMT 1205PDR-RM-MM 12.75 5.00 1.60 0.80 • • 2.00-11.80 0.07-0.20
12.75 5.00
SDMT 120516PDR-RM-MM
• For cutting speed recommendations, see pages 542-547
For tools, see pages: F90SD-12 (204)
SDMR-HQ L/IC
Super Positive Square Insert
for Aluminum, Stainless Steel
and High Temperature Alloys
Dimensions RE S Recommended
Machining Data
Tough 1 Hard
IC28 ap fz
IC330
IC328
IC840
IC830
IC928
Designation L S RE (mm) (mm/t)
5.10 ••••••
SDMR 1205PDR-HQ-M 12.70 1.00 1.40-11.80 0.07-0.12
• For cutting speed recommendations, see pages 542-547
For tools, see pages: F90SD-12 (204)
QDCT-PDN 14
Precision Ground Neutral
insert for General Use L/IC
Dimensions 23 Recommended Machining Data
RE S
Tough 1 Hard
IC330 ap fz
IC328
Designation L S RE (mm) (mm/t)
12.70 4.92 0.80 • 0.08-0.12
QDCT 120508-PDN 12.70 4.92 1.20-11.80 0.08-0.12
QDCT 120516-PDN 12.70 4.92 1.60 • 2.00-11.80 0.08-0.12
QDCT 120524-PDN 12.70 4.92 2.40 • 2.80-11.80 0.08-0.12
QDCT 120532-PDN 12.70 4.92 3.20 • 3.60-11.80 0.08-0.12
QDCT 120508-PDN-F 12.70 4.92 0.80 • 1.20-11.80 0.08-0.12
QDCT 120516-PDN-F 12.70 4.92 1.60 • 2.00-11.80 0.08-0.12
QDCT 120524-PDN-F 12.70 4.92 2.40 • 0.08-0.12
QDCT 120532-PDN-F 3.20 • 2.80-11.80
3.60-11.80
• Inserts with corner radii larger than 0.8 mm should be used only on the face of the SDK cutter • For cutting speed recommendations, see pages 542-547
For tools, see pages: F90SD-12 (204) • FDN (342) • FST (361) • SDK-12-C/HP (250) • SDN (353) • SSB (362)
497