Page 28 - FAST_FEED_MILL_Brochure_INCH_2022
P. 28
DCONMS
DHUB
FFQ4 D-17
Fast Feed Face Mills Rd°
Carrying Single-Sided Inserts OAL
with 4 Cutting Edges
14°
DC
DCX APMX
Designation DCX (2) DC APMX AE (3) CICT (4) OAL DCONMS DHUB RMPX° (5) MDN (6) MDX (7) CSP (8) Arbor MIID (9) TQ (10) Lbs
FFQ4 D3.00-06-1.25-17 3.000 1.850 .1180 .574 6 2.000 1.250 2.874 1.2 4.850 5.961 1 A FFQ4 SOMT 170625T 80.00 1.79
FFQ4 D4.00-07-1.50-17 4.000 2.850 .1180 .574 7 2.000 1.500 3.228 .8 6.850 7.961 1 A FFQ4 SOMT 170625T 80.00 2.91
FFQ4 D5.00-08-1.50-17 5.000 3.850 .1180 .574 8 2.250 1.500 3.228 .6 8.850 9.961 1 B FFQ4 SOMT 170625T 80.00 4.44
FFQ4 D6.00-10-2.00-17 (1) 6.000 4.850 .1180 .574 10 2.500 2.000 5.000 .4 10.850 11.961 0 B FFQ4 SOMT 170625T 80.00 9.81
• To generate a straight surface without cusps, the width of cut must not exceed DC • Radius for programming: for insert SOMT .217" for insert SOMW .252" • When
mounting insert SOMW, APMX=.098" • For slot milling or machining with high tool overhang, the maximum depth of cut should be reduced by 50%
(1) For internal coolant, use a matching coolant set (should be ordered separately)
(2) Cutting diameter maximum
(3) Maximum plunging width
(4) Number of inserts
(5) Maximum ramping angle
(6) Machinable diameter minimum for interpolation
(7) Machinable diameter maximum for interpolation
(8) 0 - Without coolant supply, 1 - With coolant supply
(9) Master insert identification
(10) Recommended tightening torque (lbf*in) for insert screw
Spare Parts
Designation
FFQ4 D3.00-06-1.25-17 SR M5-14 IP20 BLD IP20/S7 SW6-T
FFQ4 D4.00-07-1.50-17 SR M5-14 IP20 BLD IP20/S7 SW6-T-SH
FFQ4 D5.00-08-1.50-17 SR M5-14 IP20 BLD IP20/S7 SW6-T
FFQ4 D6.00-10-2.00-17 SR M5-14 IP20 BLD IP20/S7 SW6-T
28 FAST FEED MILLING