Page 205 - MILLING CATALOG p319-550

FF WOCT/WOMT/WOMW S1 RE ...CS IC882 Rd°
Arc Cutting Edge Inserts L IC IC328
for Fast Feed Machining IC928Recommended
at Small Depths of Cut INSBD APMX IC908Machining Data
S IC910
Tough 1 Hard
Dimensions MILLING INSERTS

ap fz

Designation IC L S S1 INSBD RE Rg(3) APMX ••• (mm) (mm/t)
2.00
FF WOCT 060212T 9.86 7.00 2.70 4.20 5.60 2.00 3.00 1.00 •• 0.30-1.00 0.30-1.00
2.00
FF WOMT 060212T-M 9.86 7.00 2.70 4.20 5.60 2.00 3.00 1.00 0.30-1.00 0.70-1.50
2.00 • 0.50-1.00 0.50-3.50
FF WOMW 060212T-M (1) 9.86 7.00 2.70 4.70 5.60 2.00 3.00 1.00
2.00 4.00 1.50 • • •
FF WOCT 09T320T 14.50 10.60 3.95 6.50 9.30 0.70-1.50 0.30-1.00
• 1.50-2.00 0.70-1.20
FF WOMT 09T320-CS (2) 14.50 10.60 3.95 6.50 9.30 4.20 2.00 • • • 0.70-1.50 0.70-2.00

FF WOMT 09T320T 14.50 10.60 3.95 6.50 9.30 4.00 1.50 • 0.80-1.50 0.50-3.50

FF WOMW 09T320T (1) 14.50 10.60 4.00 6.50 9.30 4.00 1.50

• For cutting speed recommendations, see pages 542-547

(1) Used for heavy machining, interrupted cuts and for hardened steel.

(2) Chip splitting insert - effective at depths of cut larger than 0.75 mm.

(3) Radius for programming
For tools, see pages: FF EW (304) • FF EW-CF (305) • FF EW-M (305) • FF FW (309)

FF WOMT FF WOCT FF WOMW

For general applications For high temperature alloys For hard material and
and stainless steel interrupted cut

FFT3 WXMT 03 S Rd°
Single-Sided Small Trigon IC
Inserts for Fast Feed Milling Recommended Machining Data
RE 17˚
Dimensions APMX

Tough 1 Hard

Designation IC S RE APMX IC882 ap fz
IC830 (mm) (mm/t)
IC5820 0.20-0.60 0.20-0.80
IC808

FFT3 WXMT 030206T 4.20 2.20 0.60 0.60 • • • •

• For side plunging, the initial cutting feed is 0.08 mm/t • For cutting speed recommendations, see pages 542-547

For tools, see pages: FFT3 EFM-03 (293) • FFT3 EFM-MM 03 (293)

521